D-Link DIR-100 - Manual (Page 34)

DIR-100 Ethernet Broadband Router
Settings for PPTP conntections:
PPTP Description
IP Address Enter the IP address of the router into this field. This address must be
supplied to you by your ISP. This field will not be necessary to
configure if the Dynamic IP option is chosen above the configuring
field.
Subnet Mask Enter the IP address of the Subnet Mask into this field. This address
must be supplied to you by your ISP. This field will not be necessary to
configure if the Dynamic IP option is chosen above the configuring
field.
Gateway Enter the IP address of the gateway into this field. This address must
be supplied to you by your ISP. This field will not be necessary to
configure if the Dynamic IP option is chosen above the configuring
field.
DNS Enter the IP address of the DNS. This field will not be necessary to
configure if the Dynamic IP option is chosen above the configuring
field.
Server IP/Name Enter the Server IP address for this protocol into this field. This is the
IP address of the server computer that will be used, along with your
computer, to create the Virtual Private Network. This field must be
completed for both the Dynamic IP and Static IP options
PPTP Account Enter the PPTP account name, provided to you by your ISP, here.
PPTP Password Enter your password for this PPTP account here, as stated to you by
your ISP.
PPTP Retype
Password
Retype the password entered in the PPTP Password field.
Maximum Idle
Time
A value of 0 in this field means that the PPTP connection will remain
connected. If your network account is billed according to the amount of
time the Router is actually connected to the Internet, enter an
appropriate Idle Time value (in seconds). This will disconnect the
Router after the WAN connection has been idle for the amount of time
specified. The default value = 5.
MTU This field refers to the Maximum Transfer Unit, which is the maximum
size of a packet, in bytes, that will be accepted by the router. The
default setting is 1460 bytes. This field should not be altered unless
instructed by your ISP.
Connect Mode
Select
This function, with Connect-on-demand selected, will allow the router
to connect any workstation on your LAN to the Internet upon request.
If this function is set at Always-on, no request from the workstation
will be needed to connect to the Internet. If Manual is selected, it will
be necessary for the workstation on the LAN to manually connect to the
Internet through this router.
28