D-Link DIR-100 - Manual (Page 23)

DIR-100 Ethernet Broadband Router
Setup Wizard – Configure L2TP Client Connection
NOTE: The broadband device used for your Cable or ADSL network
connection must support L2TP pass-through so the VPN session can be
established.
The Router supports Layer 2 Tunneling Protocol (L2TP) for the Internet connection. L2TP is also used for
Virtual Private Networks (VPN). Some ISPs use L2TP to establish a client-to-server connection to their
network, and ultimately to the Internet. If your Internet connection comes through a L2TP client connection
to a server owned by your ISP, the IP settings and user account information must be pre-configured on the
remote server before network access is granted.
To configure the L2TP client connection, enter the IP and account information for the Router. Your ISP will
give this information to you if you are establishing a L2TP connection to the ISP. Click Next to continue.
L2TP Connection Setting Description
My IP Address Enter the IP address for your DIR-100 based on the
information provided to you by your ISP.
Subnet Mask Enter the Subnet Mask for your DIR-100 based on the
information provided to you by your ISP.
Gateway IP Address Enter the Gateway IP address based on the information
provided to you by your ISP.
Server IP Address Enter the IP address of the ISP server with which your router
will be conveying encrypted information. This field is based on
information provided to you by your ISP.
L2TP Account Enter the name of the L2TP account as provided to you by
your ISP.
L2TP Password Enter the L2TP password as provided to you by your ISP.
Retype Password Retype the password entered in the Password field.
17