Sea Eagle Sail kit for PaddleSki - Manual (Page 4)

Sail & Rigging
Connect the 2 piece
mast by sliding the
halves together. Then
carefully slide the mast
into the sail through the
opening at the bottom
until it is stopped by the
head cap at the other
end.
Insert the batten into the
opening near the top of
the sail. Once it is fully
inserted, tie the rope to
the fitting.
Place the mast with the
sail on it into the mast
step. Pull the sail down
as far as it will go.
Locate the rope labeled
Sail to Mast Step. Tie
one end to the corner of
the sail and the other
end to the loop in the
base of the mast step
so the sail cannot slide
up the mast during use.
CAUTION/WARNING!
The mast that is on
PaddleSki is not
insulated and could act
as an electrical conduc-
tor. Do not install the
mast near power lines
and make sure you are
clear of them in any lo-
cation, especially while
on the water.
Run the main sheet, the
longest and thickest
rope, through the grom-
met in the corner of the
sail and tie a knot so it
cannot slip through the
grommet.
Run the free end of the
main sheet through the
white ring at the back of
the boat and up next to
the seat. This rope will
control the sail when
sailing. You will need to
duck your head when
tacking.
The sail can be furled
around the mast without
removing the batten.
Tightly wrap the sail
around the mast. Run
the strap through the
center of the buckle and
out the outer slot. Pull
strap tight.
3