Sea Eagle Sail kit for PaddleSki - Manual (Page 3)

Locate the aluminum
square tubes of the U-
frame. Orient the tubes
so the front hole aligns
with cross bench hole.
Use the 2½” bolts to se-
cure them to the bottom
of the mast step bench.
Place the round tube
across the top of the
side tubes and secure
with the attached 3”
bolts.
Run the straps through
the nearest D-rings and
around the crossbar.
Pull the straps tight and
run the excess through
the buckle and tuck
under the strap.
Locate the Leeboard
Hardware. Run the
large bolt with washer
through the hole in the
side tube. Place a rub-
ber washer, leeboard,
second rubber washer
and metal washer over
the bolt. Secure with the
wing nut.
Remove the aft yoke
and replace it with the
steering yoke provided.
The yoke has a hole for
the oar pin. The hole
can be placed so you
can steer right or left
handed depending on
your preference.
Slide the oar pin onto
the handle section of
the two-part rudder. As-
semble the oar and in-
sert the oar pin into its
hole in the yoke.
Secure the oar pin un-
derneath the yoke with
the ring.
Tie the Sail Ring to the
metal rings of the D-ring
handles behind the
steering yoke.
2