Sea Eagle FastTrack Kayaks (385FT, 385FTG, 465FT) - Manual (Page 8)

Locate a relatively clean
space to unpack your
Sea Eagle and lay it out
flat. If you plan on using
your kayak in flat-water
install the skeg. DO
NOT USE THE SKEG
IN WHITEWATER.
Simply slide the skeg
into the skeg base un-
derneath the stern.
Then slide the key lock
into the small gap in the
base to lock it into posi-
tion. If the skeg will not
slide in, do not force it
(refer to page 12).
Drain Valves
When using the boat in
flat-water, screw the
caps down tightly. Open
the caps before entering
whitewater. The boat
will partially fill with
water when the drains
are open.
When opening the
drains, tuck the caps
underneath the inflat-
able floor so they do not
block the openings as
water drains out.
Partially inflate the sides
and the floor and check
that the floor is tucked
underneath the sides.
Finish inflating the floor
then sides. Working
pressure of the sides
and floor is 3.2 psi. The
floor can be inflated up
to 10 psi but is not nec-
essary to do so.
Finally inflate the keel
which only takes a few
pumps.
Deluxe Inflatable Seat
(OPTIONAL)
The Deluxe Fishing
Seat (DKS) has two in-
ternal bladders, two
white valves and two
blue straps with clips for
securing to the D-rings.
Deluxe Fishing Seats
(OPTIONAL)
Features a 17” back
height for superior back
support, sitting you 10”
off the floor for greater
fishing and casting. In-
flates and installs the
same as the , Deluxe
Kayak Seats. This seat
is featured only on the
385FTG.
7
ASSEMBLY & INFLATION