Dometic SeaLand 8812 - Manual (Page 10)

0
inSTALLATiOn – TOiLET COMPOnEnTS (cont’d)
tOOls reQuireD
• Hole saws – 1” (25 mm), 1.25” (32 mm),
2” (51 mm), 2.25” (57 mm) diameters
• Drill bit – 3/16” (4.8 mm)
1
2
3
4
8
5
6
7
thrOugh-the-FlOOr cOnnectiOns
• Phillips head screwdriver
• 3/8” (10 mm) socket wrench
Place template in desired
location.
Center-punch holes and
mounting bracket corners.
Drill hole centers as shown on
template. Do not drill mount-
ing bracket corners.
With long hex-head screws
from toilet floor bracket kit,
fasten floor brackets with 3/8”
(10 mm) socket wrench using
corner marks as guides.
NOTE: Do not completely
tighten hex-head screws to
floor – let brackets move free-
ly. Brackets will tighten when
mounting toilet to brackets
(see step 15, next page).
Plan locations of touchpad
panel and electronic control
module and optional acces-
sories so that all electrical
connections can be made.
Refer to Electrical Assembly
drawing for supplied wire
lengths.
Mount electronic control
module in cool, dry place.
Drill 2.25” (57 mm) hole for
touchpad panel.
Fasten touchpad bracket and
gasket to wall, making sure
mounting tabs are at top and
bottom.
Route ribbon cable into wall
and snap touchpad panel onto
bracket mounting tabs.