Setup & use, Mount dryer onto conveyor, Connect dryer power cord to conveyor – Rena IR7C User Manual
Page 7: Ount dryer onto conveyor, Onnect dryer power cord to conveyor
SETUP & USE:
WARNING!
HIGH TEMPERATURES
The Infrared lamps temperature may exceed 500° F. Contact with the lamps will cause severe
BURNS. Flammable objects may ignite if they are left under the lamps for too long.
REMOVE FOAM SHIPPING INSERTS PRIOR TO OPERATION
See unpacking section for removal instructions.
Mount dryer onto conveyor:
If the dryer was purchased at the same time the conveyor was purchased; the dryer will normally
be mounted onto the conveyor by your authorized Rena Systems Dealer.
Please refer to your conveyor’s operating instructions for additional details.
IR7C Dryer mounted onto TB-390 Conveyor
Connect dryer power cord to conveyor:
The power cord, supplied with the dryer, must be connected to the appropriate outlet on your
conveyor. Please refer to your conveyor’s operating instructions, to identify the proper “dryer
power connection” location on your conveyor.
WARNING: Do NOT connect the dryer directly to a wall outlet. Doing so creates a safety hazard
and may cause damage to the conveyor.
Dryer power connection (DRYER OUT) on TB-390 conveyor
IR7C_Operations_11-3-09
7