REMKO EWS300 - Manual (Page 4)

4
REMKO
EWS 300
Carefully read the operating manual
before placing the unit in service for
the first time. It contains useful tips
and notes
! such as hazard warnings
to prevent injury and material damage.
Failure to follow the directions in this
manual can result in endangerment
to persons, the environment and
the equipment itself and will void any
claims for liability.
■ Keep this manual in the vicinity of the
units.
■ The units and components should be
set up and installed only by qualified
personnel.
■ The set-up, connection, and operation
of the unit and its components must
be in accordance with the operating
conditions stipulated in this manual
and comply with all applicable local
regulations.
■ Modification of units and components
supplied by REMKO is not permitted
and can cause malfunctions.
■ Units and components may not be
operated in areas where there is an
increased risk of damage. Observe
the minimum clearances.
Safety notes
■ The electrical supply is to be adapted
to the requirements of the units.
■ The operational safety of units and
components is only assured if they are
fully assembled and used as intended.
Safety devices may not be modified
or bypassed.
■ Do not operate units or components
with obvious defects or signs of
damage.
■ The units and components must
be kept an adequate distance from
flammable, explosive, combustible,
abrasive and dirty areas or
atmospheres.
■ Installation, repair and maintenance
work may be carried out only
by authorised specialists. Visual
inspections and cleaning can be
performed by the operator as long
as power is disconnected from
the equipment.
■ To preclude any danger from the unit,
take appropriate hazard-prevention
measures when performing
installation, repair or maintenance
work or cleaning the units.