Dimplex DFG2562SS - Manual (Page 12)

12 www.dimplex.com
Operation
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DImPLEX
(1-888-346-7539).
Remote Operation
The fireplace is supplied with an
integrated on/off remote control
(Figure 7)
the hand held transmitter.
②
Install one (1) 12-volt (A23)
battery in the battery holder.
③
Close the battery cover.
battery must be recycled
or disposed of properly.
Check with your Local
Authority or retailer for recycling
advice in your area
Remote Initialization/
Reprogramming
In the event that your remote
control ceases to operate
your fireplace, follow these
steps to re-initialize the hand-
held transmitter and the remote
control receiver in the fireplace:
①
Place the Three Position on/
off switch (Figure 6A) in the off
(“ O ”) position.
②
Wait a minimum of five (5)
seconds and then place the Three
Position on/off switch in the
remote (“ II ”) position.
③
Within 10 seconds of
changing the switch position,
press the on button located on
the remote control transmitter
(Figure 7).
Figure 7
Off
button
On
button
battery
battery
Cover
! NOTE: Ensure that the
fireplace's Three Position on/
off switch is set to the remote
control (“ II ”) setting
(Figure 6A).
To operate, push the on button
to turn fireplace on, push the oFF
button to turn the fireplace off.
Battery Replacement (Figure 7)
To replace the battery:
①
slide battery cover open on