REMKO GSG-4 - Manual (Page 4)

4
Mode selector
The mode selector sets the function of the individual units.
0 = OFF
I = Heat
II = Fan
Functionality
Thermostat control is not possible for the mode setting II = Fan!
G
Operating light
The green operating light is illuminated when the operating switch of the
unit is switched to Position I (heating).
Malfunction light
The red malfunction light is illuminated when the unit was switched off
due to a problem with the burner.
Reset button
The reset button releases the safety mechanism of the heater and re-
starts the unit.
Before pressing the Reset button, you should first identify the
cause of the malfunction and fix the problem!
G
If the safety temperature limiter (STB) has switched off the burner, the
STB-RESET button in the inspection room of the heater must also be
pressed (see the operating instructions for the heater).
The REMKO GSG-4 control unit may only be connected to a 7-pole
plug of the GPA-C heating units intended for this purpose.
G