Randall Amplifiers NB KING100 - Manual (Page 5)

FRONT PANEL FEATURES-
cont
SOLO
Voiced like the Overdrive mode, the Solo mode provides an addition option for more
or less Drive & Level in the Overdrive channel. Most players will use the Solo mode for
a lead or volume boost to the normal Overdrive channel
.
LEVEL - Controls the output level of the Solo Overdrive channel. Use this knob to
achieve addti desired volume level for the Overdrive channel.
DRIVE - Controls the distortion level in the Overdrive channel. This amp was designed
to achieve a wide-range of gain levels, so set the control lower for more mid-gain classic
rock and funk tones or turned it up for full on modern rock and metal distortion.
POWER
The main power switch to the amplifier. Once the amplifier is plugged in flip the Power
switch to the ON position. The VU Meter and Clean channel will light up indicating the
amplifier is powered up and ready for action. IMPORTANT: Always make sure the Standby
is set to the Standby or OFF position anytime you turn ON or turn OFF the amplifier.
STANDBY
Once the amplifier has been powered up for a minimum of 30 seconds, you can flip
the Standby to ON and start playing. When turning the amplifier OFF, turn
the Standby to the OFF position first and let the power tubes cool down for a minimum
30 seconds before turning Power switch OFF.
VU METER
The VU meter measures the overall output of the amp. You will notice the VU Meter
is slighter higher when using the Clean channel, because the signal level is much cleaner
and stronger in this channel. Don’t be concerned if the VU meter occasionally hits the
red area.
MASTER
This large knob controls the overall volume level of the amplifier. Set the level control
on each channel first then bring up the Master volume to the desired level. This knob
increases the volume gradually, so don’t be shy about turning the Master knob up as
high as you like. The amplifier will continue to get louder without distorting to quickly.
.