Randall Amplifiers NB KING100 - Manual (Page 3)

FRONT PANEL FEATURES
CLEAN
This channel was designed for a wide-range of dynamic clean tones, but really
shines for all funk to vintage style blues tones.
BASS - This passive tone control adjusts the amount of low frequencies in the
Clean channel. Set the knob straight up then adjust for more or less bass as
needed.
MIDDLE - This passive tone control adjusts a wide-range of the mid-range
frequencies in the Clean channel. When adjusting the MIDDLE control keep
in mind that you will also be cutting and boosting upper bass frequencies and
lower Treble frequencies. Set the knob straight up then adjust as needed.
TREBLE - Another passive tone control that adjusts all upper mid-range and high
frequencies. Set the knob straight up to start then adjust in more or less highs
as needed.
LEVEL - Controls the volume level of only the Clean channel. Set this knob to
achieve the desired output level of the clean channel.
CHANNEL SELECT SWITCH
This momentary push button switch is used to scroll thru and select between the
3 channels on the amplifier. Simply push and release to change channelsand select
the desired channel. This switch is also the store function for the included MIDI
footswitch or any MIDI compatible footcontroller. To store a channel to a particular
button on the footswitch, simply press the desired footswitch button then using the
front panel Channel select button scroll thru to the desired channel. Press, hold
& release the Channel Select button for 3 seconds to store the preset. See the
MIDI implemention guide later in this manual.
INPUT
Designed to accept a standard 1/4” mono phone plug. For best results use a
high quality shielded cable to connect your guitar to the amplifier.
.