Proel WM600 - Manual (Page 6)

6
INTRODUCTION
Thank you for choosing this PROEL product and for your trust in our brand, synonymous of professionalism,
accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in
professional systems.
DESCRIPTION
The WM600 Wireless Microphones series is a UHF, PLL controlled and programmed frequency device, which
provides a reliable, high quality signal transmission.
WM600 Wireless Microphone system features 3 units: WM600 receiver, WM6M handheld transmitter and
WM6H body pack transmitter. The system is available in two different configurations, each of them including
an ABS carrying case:
WM600M:
WM600 + WM6M
WM600H: WM600 + WM6H + lavalier + headset
Four channel frequencies are available, which have been accurately selected to allow the simultaneous use of
4 devices without interference between them:
1. 863.100 MHz
2. 863.900 MHz
3. 864.500 MHz
4. 864.900 MHz
WM600 RECEIVER
See FIG. 1 at page 15:
1. DC IN
Socket for the AC/DC adaptor connection, use only the adaptor supplied with the system.
2. OUTPUT (UNBALANCED)
Unbalanced output with line level: connect it through a mono 6.3mm jack cable to a mixer input.
3. OUTPUT (BALANCED)
Balanced output with mic level: connect it through a XLR cable to a mixer input.
4. POWER
On/off switch.
5. ON
Red LED: if lighted states that the power supply is present and the receiver is turned on.
6. RF
Green LED: if lighted states that the transmitter is sending a radio signal to the receiver.
7. AF
Red LED: illuminates when an audio signal is present.
8. SET
Keep this button pressed until the number flashes and then push it again to set the receiver channel.
9. CHANNEL NUMBER
The display shows the channel number, that must correspond to the channel set on the transmitter.
10. VOLUME
Volume potentiometer: set this control to a proper level that doesn’t saturate the mixer input channel.
11. ANTENNA
These are the receiving antennas. Raise them up during the use and, to obtain a better reception, place
the receiver away from other metal objects and no more distant than 30m from the transmitter.