Posiflex PD-76X0R - Manual (Page 4)

Part 4
Stand Alone Model:
This instruction is for stand alone model only. Please
unpack the inner box of pole display and it easy to find
the base, display unit with tube and adaptor separately.
Please remove the PE foam and bring out the components
carefully.
Firstly, place the display head and tube on a flat surface
and find the cable which in the end of tube. Let this cable
pass through the short tube which on the base stand and it
shows in the picture at right.
Next, please assemble the display head with tube to the
base stand which shows in the right picture. Please pay
more attention during the process since there is a hole and
a compression lock which are in the two side of tube and
marked arrow signs. Aim these two arrow signs nearby
compression lock to the holes and push the tube to the end.
After hear the “click” sound, the assembly is complete.
Once combine the display head with tube and base stand,
please place the pole display as a horizontal position
which can easily to check the bottom plate.
Please plug the cable to the connector which showing “To
Display” and route the cable as arrowed in the right
picture.
DRIVER INSTALLATION
For application software to use the RS232 interfaced PD-7600 series, there is
no direct need for any driver.
APPLICATION GUIDES
CONTRAST ADJUST
Use the 2 buttons on right side of the display head front
surface to increase / decrease the contrast of LCD