beautypg.com

Posiflex PD-2600 User Manual

Page 8

background image

Part 8

Fixing pole display base to system

To fix the PD-2602 to base of KS or TP systems, please connect the interface

cable of PD-2602 through the cable exit in base as
in Pix. 9 a peeping view
of pole display joint base
bottom to the appropriate
port in main unit passing
the inside of system base

as indicated in the top-view picture Pix. 10. Match the
pole base (joint mechanism) to the system rear connect
area Fit 2 screws through washers at arrowed points
to hold the joint tight.

INSTALLING PD-2603

Open back cover on system

First push in the circled knobs on
both sides as in Pix. 11 to
remove the back cover.

Remove pole cover

Remove the pole cover on rear edge of the base top
cover of FT system by first removing the 2 arrowed
screws in Pix. 12 and then pushing the wedge shaped
pole cover up.

Install PD and connect interface cable

Insert the base of PD-2603 / PD-2603U from top of
FT system base with the flat side of the pole base
facing the back cover direction and screw back the 2
screws as in Pix. 13. Connect the interface cable to
appropriate port.

COMMAND EMULATION MODE SETUP







Pix. 9

Pix. 10

DIP switch
window

Pix. 14

Pix. 12

Pix. 11

Pix. 13