Posiflex PD-2600 - Manual (Page 5)

Part 5
INSTALLING PD-2601
Opening the back cover on system
For ease of PD-2601 installation operation, the HT main unit
or PB system has to be opened with sufficient precautions.
First push in the circled knobs on both sides as in Pix. 1 to
remove the back cover. Take out the arrow pointed pole
cover from it.
Opening the top cover of system
Prepare a piece of clean soft clothe of appropriate size in
front of the HT system to prevent damage. Turn the display
panel to straight up position. For both HT and PB system, push in the
rectangular marked spring button in Pix. 1 on both sides of chassis and raise
the rear edge of the top cover. The COM port DC support can be set at this
moment.
Find joining points on system
Refer to Pix. 2 that is a picture of the HT or PB chassis near the right bottom
corner (as you are facing the HT or PB system from its back) with several
portions enlarged around, please find 2 rectangular PD installation holes A on
the bottom chassis; 2 circular locating holes B on I/O plate; and 2 circular
screw holes C on metal sidewall.
Find joining points on pole display base
Pix. 1
A
A
B B
C
C
Pix. 2
A’
A’
B’ B’
C’ C’
Pix. 3