Posiflex TX-4200E - Manual (Page 7)

Page 7
INSTALLATION GUIDES
Hardware Power Switch
The power switch located in the front bezel of main
unit. It is a pushbutton switch and controls the power
on/off of the whole system.
This power switch turns the system on when pushed
only. This switch turns the system off when pushed
again during power on status. However, if the system hangs due to any reason
such as software resource conflict, a simple push on the switch in 10 sec may
turn off the power.
Note: There must always be at least 10 seconds waiting before switching
on again once the system is powered off successfully.
Indicators of power, status and HDD
There are two indicator LED modules serving for several
purposes at front bezel. For HDD indicator, it will flash
orange light when the HDD is operating. The relationship
between the indicator status and other conditions of “Power
LED” is summarized in the following table:
CAUTION: Before any installation or cable connection to the set, please
always make sure that the system is turned off and the external power
source to the set is removed to prevent electric hazard! Never touch any
metal pin in the connectors or circuits to avoid high voltage hazard or
electrostatic discharge damage unless the operator is well grounded.
Failure to do the above will void the product warranty!
Display Issues
VGA Port
The VGA port in the TX series system supports either a separately connected
LCD monitor or touch monitor. To support the DC power to the display
monitor, it requires a qualified technician to set up through BIOS setting. To
Indicator Terminal Status LED colour
Standby Orange
Power Status
Power On Blue