Gas connection, Warning, Danger – Permasteel PG-4030000L User Manual

Page 10

1) Make sure tank valve is in its full off position (turn clockwise to stop).
2) Check tank valve to assure it has proper external male threads.
3) Make sure all burner knobs are in their off position.
4) Remove the protective cap from tank valve. Always use cap and strap supplied

with valve.

5) Inspect valve connection port and regulator assembly. Look for any damage or

debris. Remove any debris. Inspect hose for damage. Never attempt to use
damaged or plugged equipment. Contact your local gas dealer for repair.

6) When connecting regulator assembly to the valve, hand tighten nut clockwise

to a positive stop. Do not use a wrench to tighten. Use of a wrench may damage
quick coupling nut and result in a hazardous condition.

7) Open tank valve fully (counterclockwise). Use a soapy water solution to check

all connections for leaks before attempting to light grill. If a leak is found, turn
tank valve off and do not use grill until a local gas dealer can make repairs.

!!! WARNING !!!

Never insert any foreign objects into the valve outlet. It may damage the valve and

cause leak, leaking may result in fire, explosion, heavy body injury, or even death.

Do not use this grill until leak tested.

STOP and call the fire department if any leaks are detected.

If you cannot stop a gas leak, close the tank valve IMMEDIATELY, call gas supplier

or the fire department.

!!! DANGER !!!

NEVER store a spare tank under or near grill or in an enclosed area.

NEVER fill the tank beyond 80% full. An overfilled spare tank is dangerous

because surplus gas may leak from safety relief valve. The safety relief valve on a
tank could activate to release gas and cause a fire.

The spare tank must have safety caps installed on the tank outlet.

If any gas leaks are found on the spare tank, immediately step away from the grill,

and call the fire department.

VERY IMPORTANT:

DISCONNECT THE TANK WHEN THIS GRILL IS NOT IN USE.

To disconnect gas tank:

1) Turn all the knobs off.
2) Turn the tank valve off fully (turn clockwise to stop).
3) Detach the regulator assembly from tank valve by turning the quick coupling nut

counterclockwise.

4) Install the protective cap back onto the tank valve.

GAS CONNECTION