Permasteel PG-50506SRLA - Manual (Page 17)

14
ONLY USE THE REGULATOR AND HOSE ASSEMBLY PROVIDED
WITH THIS GRILL. REPLACEMENT PRESSURE REGULATORS AND
HOSE ASSEMBLIES MUST BE THOSE SUPPLIED BY THE
MANUFACTURER
This is a LP (Liquefied Petroleum Gas) configured grill. Do not attempt to use a natural
gas supply unless the grill has been reconfigured for natural gas use.
The installation of this appliance must conform with local codes or, in the absence of
local codes, with either the National Fuel Gas Code, ANSI Z223. 1, or CAN/CGA-
B149.2 Propane Installation Code.
ƒ LP TANK REQUIREMENTS – THE LP TANK USED WITH YOUR GRILL MUST
MEET THE FOLLOWING
1) Measurement: 12’’(30.5cm) (Diameter) X 18’’ (45.7cm) (Tall) .
2) Maximum Capacity: 20lbs(9Kg).
3) Constructed and marked in accordance with the specification for LP-gas
cylinders of the U.S. Department of Transportation (DOT) or the National
Standard of Canada, CAN/CSA-B339, Cylinders, Spheres and Tubes for the
Transportation of Dangerous Goods. See LP tank collar for marking.
4) Is arranged for vapor withdrawal.
5) Includes a collar to protect the tank valve.
6) Has no dents or rust. A dented or rusty L.P. tank may be hazardous,and
should be checked by your supplier.
7) Provides a shut-ff valve terminating in an LP gas tank valve outlet specified, as
applicable for connection type QCC1 in the standard for compressed gas tank
valve outlet and inlet connection ANSI/CGA-V-1.
ƒ LP TANK VALVE USED MUST MEET THE FOLLOWING
1) Have type I outlet compatible with regulator provided.
2) Have safety relief valve.
3) UL listed Overfill Protection Device (OPD), This OPD safety feature is
identified by a unique triangular hand wheel. Only use tanks equipped with this
type of valve. (As the figure shown on the next page)
ƒ FOR YOUR SAFETY
Ensure that the black plastic grommets of the regulator provided are in place and
that the hose does not come into contact with the heat shield or the grill head.
GAS CONNECTION