Permasteel PG-40503S0L - Manual (Page 29)

26
VERY IMPORTANT: ALWAYS INSPECT THE HOSE PRIOR TO EACH USE.
ƒ BEFORE LIGHTING:
Inspect the gas supply hose before turning the gas “ON”. If there is evidence
of cuts, wear, or abrasion, it must be replaced before use. The replacement
hose assembly must be that specified by the manufacturer.
ƒ VERY IMPORTANT: TO LIGHT MAIN AND SIDE BURNERS OF THE GRILL:
1) Read instructions before lighting.
2) Turn all knobs to “OFF” then open the LP tank valve. Always keep your face
and body as far from the grill as possible when lighting.
3) Open lid during lighting.
4) Push and hold electronic ignition button.
5) If ignition does not occur in 5 seconds, turn the burner controls ”OFF”, wait 5
minutes, and repeat the lighting procedure.
6) To ignite any other Main Burner turn knob to “HI”
7) To Ignite the side burner, follow steps 4-6 using the Side Burner knob.
ƒ
TO LIGHT THE MAIN AND SIDE BURNERS BY MATCH: (AS THE
FOLLOWING FIGURE SHOWS)
If the burner will not light after several attempts then the burner can be match lit.
Tools: Lighting rod (hanging behind the right door)
Usage:
1) Read instructions before lighting.
2) Open the lid during lighting.
3) Simply place a lighted match between the coils on the end of the lighting
rod and hold next to the burner to ignite.
4) Push and hold electronic ignition turn the burner controls ”HI”
5) Repeat 3.4 to light other burners.
6) Keep a spray bottle of soapy water near the gas supply valve and
check the connections before each use. Do not light the grill if odor
of gas is present, call out service center at (888)-287-0735.
GRILL LIGHTING INSTRUCTION
Keep a spray bottle of soapy water near the gas supply valve and check the
connections before each use. Do not light the grill if odor of gas is present,
call our service center.