Paso Sound PDVD01U - Manual (Page 13)

TASCAM DV-D01UT/C
1
Basic operations
Turning the unit on/off
Press STAND-BY/ON.
The following messages will appear on the TV screen.
NOW READING
“OPEN”/”CLOSE”:
Appears when opening or closing the disc tray.
“NOW READING”:
Appears when the system is reading the disc/file
information.
“REGION CODE ERROR!”:
Appears when the Region Code of the DVD VIDEO does
not match the code the system supports. The disc cannot
be played back.
“NO DISC”:
Appears when no disc is loaded.
“CANNOT PLAY THIS DISC”:
Appears when unplayable disc is loaded. •
•
•
•
•
NOTE
A small amount of power is consumed even when the power
is turned off. This is called standby mode. Unplug the power
cord from the AC outlet to turn the power off completely.
You can also turn on the unit by pressing the following
buttons;
The ø button on the unit or OPEN/CLOSE on the remote
control
The ¥ (play button) on the unit or remote control
When connecting your TV through HDMI terminal, turn on
the TV before turning on the unit; otherwise, the following
phenomena may happen depending on the TV.
The scan mode setting (see page 10) is changed.
The sound comes out from the speakers on TV even
though “HDMI AUDIO OUT” in the AUDIO menu (see
page 27) is set to “OFF”.
If the above phenomena happen, turn off the unit and turn it
back on, then set the scan mode again.
Adjusting the brightness of the
indications [DIMMER]
Press DIMMER.
Each time you press the button, you can change the brightness
level in 3 steps.
•
•
–
–
•
–
–
The buttons on the remote control are used to explain most
of the operations in this manual. You can use the buttons on
the unit same as on the remote control for operations unless
otherwise noted.
The buttons described below are used on pages 9 and
10.
DIMMER
SCAN
PROGRESSIVE
STAND-BY/ON
Cursors/ENTER
STOP OPEN/CLOSE PLAY
STAND-BY/ON