Pacific Cycles BIRDY Monocoque hinge adjustment User Manual
Page 2

Birdy/Equinox: replacement of sleeve at folding hinge
P:\08_Anleitungen\Fahrradmontagen\GB-WORD-2002\BE Hülse austauschen-GB-2006-07-07.doc / Stand: 2006-08-24
Page
2 of 3
Assembly
1.
Grease the exzenter and insert it into the left side
of the folding hinge. Do not forget the washers
A!
2.
Insert the greased bolt from the right side and
assemble the right bolt M4 incl. the small washer.
Do not forget the washer
A.
Hold the excenter while tightening the bolt M4 (just
put the lever onto the left side of the excenter).
3.
Push the excenter to the right side again until the
grub screw is accessible. Tighten the grub screw as
much as possible (1 Nm tightening torque). Then
tighten the right bolt M4 again.
4.
Push the excenter to the left side and turn the flat
section facing to the top.
5.
Assemble the lever including the washer. Assemble
the cap.
Important: secure the left bolt M4 by a drop of Loc
tite medium threadlocker.
6.
Adjust the axial play of the excenter by turning the
left bolt M4. Do not tighten the bolt to much be
cause the lever will be hard to move.
7.
8.
Put the black clamp onto the tension rod.
9.
Turn the cone three times on the tension rod. Insert
both into the open folding hinge.
Attention: the short side of the cone has to face
up.
10.
Close the folding hinge. Apply some Loctite medium
threadlocker at the bolt M4x12 and assemble it at
the black clamp (tightening torque 1 – 2 Nm).