Osburn 1000 - Manual

FABRIQUÉ AVEC FIERTÉ AU CANADA / PROUDLY MADE IN CANADA
45105A
COMBINED FAN INSTALLATION INSTRUCTIONS
FOR OSBURN MODELS
1000, 1100 & 1600 WOODSTOVES
COMBINED INSTRUCTIONS
1. Do not operate the fan or plug it in without the fan being permanently installed on the stove (fire).
2. When the fan is in place, the electrical cord should be routed as close to the floor as possible and outside
the hearth, away from the unit and wall clearances. Route the electrical cord away from the unit to prevent
damage to the cord insulation. Plug into a standard three prong 110-volt outlet or a 240-volt outlet for use
in Australia.
3. Make sure that the fire in the stove is out, and it has cooled down to room temperature before any
maintenance.
4. Follow normal instructions to continue burning.
OSBURN 1000
1. Install the two formed mounting plates onto the fan housing as shown in figure 1 and fasten with the four
provided screws (a) through the holes as indicated.
2. Remove the two bottom heat shield screws (b) and locate the fan and mounting plate assembly between
the inside of the heat shield and the two heat shield spacers as shown in figure 2.
3. Replace the heat shield screws through the heat shield holes, the mounting bracket slots and into the
spacers to secure the assembly.
OSBURN 1100
1. Install the two formed mounting plates onto the fan housing as shown in figure 3 and fasten with the four
provided screws through the holes as indicated.
2. Align the holes of the mounting plate with the holes on the outside of the heat shield and fasten with the
two provided screws as shown in figure 4.
3. For insert applications, turn the fan switch to the high speed position before installation.
OSBURN 1600
1. Install the two formed mounting plates onto the fan housing as shown in figure 1 and fasten with the four
provided screws (a) through the holes as indicated.
2. Align the holes of the mounting plate with the holes on the outside of the heat shield and fasten with the
two provided screws as shown in figure 5 and 6.