Osburn OB01601 User Manual
Page 15
15
5.
If lag-bolts and anchors are to be used to secure the insert, the hole locations
should be marked with the unit in place. Remove the unit and locate the anchors.
6.
Remove the faceplate panels from their box and assemble according to these
faceplate instructions:
A.
Remove the slide from within the air jacket.
B.
Place the faceplate face down on a flat, nonabrasive surface (see Figure 6) so that
the sides are a bit towards the middle.
Figure 6
C.
Place the slide onto the faceplate so that the bends of the faceplate pieces go
inside of the slide.
D.
Line up the holes by pushing the sides out and install (smooth heads inside) all the
bolts loosely. Line up the edge of the faceplate top and side, tighten the two bolts
joining them, and then tighten the side bolts. Tighten the bolts on the other side in
the same manner (see Figure 7).
Figure 7