Olson Technology OTPN-800CH - Manual (Page 2)

SAFETY WARNINGS
LASER RADIATION
The OTPN-800CH may be equipped with a laser transmitter which emits invisible
radiation that can cause permanent eye damage. AVOID DIRECT EXPOSURE TO
BEAM. Operate the transmitter only with the proper optical fiber installed in the
transmitter optical connector. Power to the OTPN-800CH should be turned-off or
preferably, disconnected whenever the optical connector cover is opened and there is
no installed fiber (as when the fiber connector is being installed or removed from the
transmitter connector).
NEVER
NEVER
NEVER
NEVER
USE ANY OPTICAL INSTRUMENT TO VIEW THE OUTPUT OF THE
LASER TRANSMITTER. “OPTICAL INSTRUMENT” INCLUDES MAGNIFYING
GLASSES, ETC.
LOOK INTO THE OUTPUT OF THE LASER TRANSMITTER
LOOK INTO THE OUTPUT OF A FIBER CONNECTED TO A LASER
TRANSMITTER.
LOOK INTO OR USE ANY OPTICAL INSTRUMENT TO VIEW THE
DISTANT END OF A FIBER THAT MAY BE CONNECTED DIRECTLY OR VIA AN
OPTICAL SPLIT, TO A TRANSMITTER THAT MAY BE OPERATING. THIS
SPECIFICALLY APPLIES TO FIBERS THAT ARE TO BE CONNECTED TO
RECEIVERS (SUCH AS THE OTPN-800CH) OR OTHER DEVICES AT ANY
DISTANCE FROM THE LASER TRANSMITTER.
HIGH VOLTAGE
SHOCK HAZARD
The power supply section (bottom section) of the OTPN-800CH contains no user
serviceable parts. There is exposed high voltage inside this section. Only factory
service technicians should open the power supply section.
The OTPN-800CH is designed for indoor use only. Direct exposure to moisture must be
avoided. Connect the AC Adapter into the OTPN-800CH
plugging the adapter
into the wall.
BEFORE