Olson Technology OTOR-300 - Manual (Page 2)

025-000442 REV X2 Page 2
TABLE OF CONTENTS
INTRODUCTION Page 3
INSTALLATION Page 3
Installation / Environmental Considerations Page 3
Optical Connectors and Cleaning Page 4
Setup Procedure Page 4
ACCESSORIES Page 5
RELATED OLSON TECHNOLOGY PRODUCTS Page 5
Top View of OTOR-300 Page 6
SAFETY WARNINGS
LASER RADIATION
NEVER LOOK INTO THE OUTPUT OF A FIBER CONNECTED TO A LASER
TRANSMITTER.
NEVER LOOK INTO OR USE ANY OPTICAL INSTRUMENT TO VIEW THE DISTANT
END OF A FIBER THAT MAY BE CONNECTED DIRECTLY OR VIA AN OPTICAL SPLIT,
TO A TRANSMITTER THAT MAY BE OPERATING. THIS SPECIFICALLY APPLIES TO
FIBERS THAT ARE TO BE CONNECTED TO RECEIVERS (SUCH AS THE OTOR-300) OR
OTHER DEVICES AT ANY DISTANCE FROM THE LASER TRANSMITTER.
HIGH VOLTAGE
The inside of the OTOR-300 contains no user serviceable parts. There is exposed high voltage inside this
unit. Only factory service technicians should open the unit with power applied.
FIRE HAZARD
The AC line input fuse is contained in the IEC 320 power input connector. This fuse is a 250V, 0.5A,
5x20mm, slow blow fuse. To avoid a risk of fire, this fuse should be replaced only with an identically rated fuse.
SHOCK HAZARD
The OTOR-300 is designed for indoor use only. Direct exposure to moisture must be avoided.
The OTOR-300 return receiver receives invisible radiation that can cause
permanent eye damage. AVOID DIRECT EXPOSURE TO BEAM.