Olson Technology OTEN-4P-01 - Manual (Page 4)

025-000502 Rev. X2 www.olsontech.com 2
INTRODUCTION
The OLSON TECHNOLOGY, INC. Model OTEN-4P-01 EtherNodePlus 4-Port Media Converter
supports two 10/100/1000Mb/s UTP ports and two 1000Mb/s SFP sockets to convert between
1000Base-T, 1000Base-SX, 1000Base-LX, etc. This allows network operators to convert signals
between an electrical Ethernet 10/100/1000Mb/s UTP interface and an optical interface. The tradi-
tional 10/100/1000Mb/s gigabit Ethernet signal can be extended to distances of 80+km through an
optical fiber.
The OTEN-4P-01 incorporates the latest gigabit IC technology. Indicator LED’s on the front panel
allow the unit’s status to be fully monitored, simplifying installation and maintaining network
performance.
PANEL LAYOUT
Figure 1 — Converter Front Panel
LED INDICATOR FUNCTIONS
Designation Meaning
100 Lit when TP1 or TP2 speed is 100Mb/s.
1000 Lit when TP1 or TP2 speed is 1000Mb/s.
Link/Act
Lit when the TP1 or TP2 connection is good.
Blinks when TP1 or TP2 data is transmitting.
SFP1
Lit when SFP1 connection is good.
Blinks with SFP1 data is transmitting.
SFP2
Lit when SFP2 connection is good.
Blinks with SFP2 data is transmitting.
PWR Lit when the unit is powered.
ETHERNET SPECIFICATIONS
Parameter Specification
Standards IEE802.3z/AB, 10/100/1000Base-T and 1000Base-SX/LX/HX
Cables UTP Category 5e or Category 6 (100m max. distance)
50/125µm Multimode Fiber (500m max. distance at 1000Mb/s)
9/125µm Single-mode Fiber (80+km max. distance)
Connectors UTP: RJ-45, 10/100/1000Mb/s
Optical: SFP Module
Mac Add. Table 1K
Data Buffer 512K
Flow Control Full-duplex IEEE802.3x
Half-duplex Back Pressure