Olson Technology LP-CH-16B - Manual (Page 10)

025-370403 REV X9 Page 10 of 11
REAR PANEL
The RF output connectors are on the rear of the unit. Receiver #1 is on the top. Receiver #3 is on the
bottom.
INTERNAL ADJUSTMENTS
There are 3 jumpers that are accessible from the side that are used to set the receiver input range. The
jumpers can be changed with tweezers or needle nosed pliers. The nominal level for changing jumper posistions is
-3dBm.
FUSE
The module has an internal miniature 3A SB fuse in a holder. The Littelfuse part number is 0454003. The
Olson Technology P/N is 286-000009.
OPTICAL INPUT CHART
The following chart shows the test point readings versus optical input levels.
T.P. Volts Optical Input mW Optical Input dBm
3.02 3.02 4.8
2.51 2.51 4
2.00 2.00 3
1.58 1.58 2
1.26 1.26 1
1.00 1.00 0
0.79 0.79 -1
0.63 0.63 -2
0.50 0.50 -3
0.40 0.40 -4
0.32 0.32 -5
0.25 0.25 -6
0.20 0.20 -7
0.16 0.16 -8
0.13 0.13 -9
0.10 0.10 -10
0.08 0.08 -11
0.06 0.06 -12
0.05 0.05 -13
0.04 0.04 -14
0.03 0.03 -15
RETURN FREQUENCY MULTIPLIERS
The Laser Plus system includes 3 receiver/ down converter modules that can be used as part of a return
band frequency multiplier system. This system can quadruple the bandwidth of a new or existing return link. Olson
Technology builds up converters to fit inside the nodes of several manufacturers. Consult the factory for the latest
list of compatible nodes.
See the LPDC-212 / LPDC-234 instruction manual, OT # 025-370447, for more details.