Northern Airborne Technology RS12 - Manual (Page 15)

SM15 Rev.4.00 RS12/RS24 Remote Switch Manual
Nov 24, 2003 Page 2-1
ENG-FORM: 805-0104.DOT
Amendment #1 May 12, 2005
PROPRIETARY AND CONFIDENTIAL TO NORTHERN AIRBORNE TECHNOLOGY LTD.
Section 2.0 Installation
2.1 Introduction
Information in this section consists of: unpacking and inspection procedures, installation
procedures, post-installation checks, and installation drawings.
2.2 Unpacking and Inspection
Unpack the equipment carefully and locate the warranty card. Inspect the unit visually
for damage due to shipping and report all such claims immediately to the carrier
involved. Note that each unit should have the following:
- RS12/RS24 Remote Switch
- Warranty Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately
to your supplier.
Complete the warranty card information and send it to NAT when the installation is
complete. If you fail to complete the warranty card, the warranty will be activated on
date of shipment from NAT.
2.3 Installation Procedures
2.3.1 Warnings
Do not bundle any lines from this unit with transmitter coax lines. Do not bundle any
logic or DC power lines from this unit with 400 Hz synchro wiring, or AC power lines, if
audio wiring is run through this switch. If 400 Hz RMI wiring is run through this switch,
keep away from all other audio wiring.
2.3.2 Notes
The RS24 consists of two completely independent RS12’s. All RS12 interconnect and
connector maps can be used to assist in the installation of the RS24.