NewTek TalkShow VS-100 - Manual (Page 72)

Page | 64
FIGURE 64
Notice that there are three buttons nested just below the Video Output monitor in this
pane. At any time, these buttons control what is sent to the video output.
Hint: The first and third buttons are actually action buttons, and clicking them immediately sends
the corresponding selection to output. The center button is a mode button, enabling automic
control over video output.
The buttons, in order, select the following Call video output source (or mode):

Caller Video – always sends Call video, if available; otherwise, it sends the
grabbed still image, or the ‘NoCall’ image (see Section 6.2.1).

Automatic – display Call video unless resolution falls below the minimum (see
Section 6.2.1), in which case the source selected in the No call option menu is
displayed.

Snapshot – immediately displays the snapshot, regardless of the status of
incoming Call video.
TalkShow’s Genlock feature allows it to ‘lock’ its video output to a reference video signal
supplied to its Genlock input connector.