Nevion CP44-MEC+ - Manual (Page 8)

IP Based Control Panels Rev. P
nevion.com | 8
2.3 Power connection
Do not connect mains to the power supply before connecting the power supply to
the panel.
Connect the DB9 female connector from the desktop power supply to the main unit. Tighten
the screws to assure a proper contact. To connect mains to the desktop power supply you
need a mains cord with IEC 320 connector.
The VikinX IP-based Control Panels are normally delivered with the desktop power model
AC ±5V/35W. Upon customer request the panels can also be delivered with DC ±5V/30W,
which may be fed by a 36
– 72 VDC mains power source. A Frame mounted power supply
solution is also available.
Please refer to the latest VikinX Product Catalogue for power supply types, or call Nevion for
this information.
Current draw by the panels, without any load on the GPI output:
CP-44MEC +5V / 1.2A
CP-16LCD +5V / 1.1A
CP-MDP +5V / 1.7A
The following pin-out is used on the DB9 male power connector:
Pin# 1 and 9 0V / GND
Pin# 2 and 5 +5V.