Nevion SL-3GHD128128 - Manual (Page 11)

SL-3GHD128128 Rev. D
nevion.com | 11
3
Configuration
This chapter provides an overview of the configuration options that are available on the
SL-3GHD128128 router.
Switches 1 - 4 on the configuration switch are not in use and must be kept in the
OFF position (factory default).
Some of the configuration options demand software configuration, using the Nevion
Configurator. This tool is supplied with each router, but can also be downloaded from our
web site:
www.nevion.com/support
It is important that users apply Nevion Configurator v4.1.1 (or a higher version
number) when configuring the SL-3GHD128128 and its variants.
3.1 Power Supply setup
Before proceeding with router configuration, make sure the accompanying power supply
unit is configured for the right AC supply voltage.
There is a switch on the rear side of the power supply module that selects mains voltage.
The mains voltage can be either 110VAC or 230VAC.
This switch must be set in the correct position, depending on the mains voltage on the
router’s site.
Failing to select correct AC mains voltage properly may damage the Power
Supply Unit.
3.2 Router mode
SL-3GHD128128 allows easy splitting of the router into a maximum of 4 pre-defined
partitions.
You may not control these pre-defined partitions individually if you use the DIP
switches to configure partitions. Leave switches 5
– 6 in the default position and
configure the number of individually controlled partitions you like, using the
Nevion Configurator that comes with the router. Software configured partitions
may be of any size.
You can choose among the following pre-defined partitions:
Router partitions Partition sizes
1 partition 128x128
2 partitions 64x64
3 partitions 42x42
4 partitions 32x32
Switches 5 - 6 on the configuration switch set the number of pre-defined partitions. The
Router Management System software must be configured according to the chosen setup.
The number of pre-defined partitions is selected according to the following pattern:
SW 5 SW 6 Router partitions
OFF OFF 1 partition
OFF ON 2 partitions
ON OFF 3 partitions
ON ON 4 partitions
Default mode is 1 partition.