Nevion DA-VA - Manual (Page 5)

DA-VA Rev. H
nevion.com | 5
2
Specifications
2.1 Electrical Input
Maximum input 2 V p-p
Coupling DC
Impedance 75 ohm (switch able to high impedance)
Connector BNC
Passive loop through is available with –C2 backplane (default backplane).
2.2 Electrical Output
Number of outputs 6
Connector BNC
Impedance 75 ohm
Signal polarity 6 non inverting
2.3 Analog video
Frequency range 0 to 200 MHz -3dB (useful for AES-3id)
Return loss > 40dB @ 20MHz
Video S/N ratio > 70 dB
Differential gain < 0.1 %
Differential phase < 0.1 º
Gain 0 dB ± 0.05 dB 0-10 MHz
0 dB ± 0.5 dB 0-150 MHz
2.4 Specifications for the analog amplifier used for SDI-video
(SMPTE 259 M)
Gain 0 dB
Jitter < 700 ps, typ. 250 ps
Return loss > 15dB @ 270MHz
Data rate up to 270 Mbps
Rise/fall overshoot < 10 %, typ. 0 %
Rise and fall time > 400 ps, < 1500 ps, typ. 1000 ps
Rise/fall time difference < 500 ps, typ. 100 ps
2.5 Electrical
Power +5V DC / 0.1 W,
±15V DC / 1.9 W
Control Control system for access to setup and module status
with BITE (Built-In Test Equipment) for use with GYDA
Control System