Nevion DA-VAEQ-6 - Manual (Page 6)

DA-VAEQ-6 Rev. B
nevion.com | 6
3
Connections
The DA-VAEQ-6 has a dedicated connector module: DA-VA-C2. This module is mounted at
the rear of the sub-rack. The module is shown in figure 2.
Figure 2: Overview of the DA-VA-C2 connector module (default backplane).
The electrical input signal is connected to the two IN BNCs, and the electrical outputs are
connected to the O1 to O6 BNC’s. Please note that all 6 outputs are non-inverted. On the
back side of this board, there is a DIP switch (see figure 5 in chapter 4.4) to set the
termination. If switch 1 is on, there is a 75 ohms termination. DIP switch 2 is not used.
3.1 Mounting the connector module
The details of how the connector module is mounted, is found in the user manual for the
sub-rack frame FR-2RU-10-2.
This manual is also available from our web site: http://www.nevion.com/