Museum Technology Source TDR-10 Timed Power Control - Manual

TDR-10 TIMED POWER RELAY
*Switches on AC Outlet for Preset Time
*Triggered by Motion Sensor or Pushbutton
*Protects Artifacts from Excess Light Exposure
*Adjustable from Seconds to Hours
Front Panel
Rear Panel
The TDR-10 Timed Power Relay serves to turn on a standard
120 Volt outlet for a preset amount of time. This timed interval is
initiated when a contact is made across the Start terminals on
the rear panel. This low voltage contact may come from a push-
button, motion sensor, or other device.
Once triggered, the timing cycle starts and the outlet switches
on. While timing, any additional start signals force the timing
cycle to begin anew. This ensures that there will be at least one
complete cycle after the last start signal. For example, if used
with a motion sensor such as the Museum Technology BB-200,
the first visitor to approach will turn on the AC outlet for the pre-
set time. If no further motion is sensed, the outlet will switch off
at the end of the preset time. Should another visitor approach
while the outlet is on, the TDR-10 will start the timing cycle from
the beginning. In this way, as long a visitor motion is detected,
the outlet will remain on, shutting off only after motion has not
been sensed for the preset time.
Switched 120
Volt Outlet to
power exhibit Screw terminals to con-
nect to motion sensor
or pushbutton
Specifications
Timing Range: .05 seconds to 100 Hours
Accuracy: Within .05%
Input Voltage: 120 Volts, 60 Hz
Switching Capacity: 500 Watts
AC Power Input: Detachable IEC Cord supplied
AC Power Output: One standard NEMA-15 AC outlet
Motion Sensor Power: 24 Volts AC, 200 mA
Start Input 4 position 5.08 mm plug with screw
terminals.
Physical: 5.5” wide 5” deep 2.5” high, 2 lb
Case: Aluminum Extrusion and steel
Warranty: 2 Years Parts and Labor
Country of Orgin: United States
Museum Technology Source Inc.
323 Andover Street Wilmington MA 01887
800-729-6873 | 978-657-3898 | f 978-657-7132
www.museumtech.com
Museum Technology Source Inc.
Sets ON time...from a fraction of
a second to 100 hours
Connect to 120 Volt supply
with supplied cord