MultiDyne SMPTE-HUT - Manual (Page 9)

SMPTE HUT Manual 10/15/2014
Multidyne Electronics Inc.
9
To avoid having to set the Ikegami CCUs for single fiber mode, you can configure the HUT-
CCU specifically for your Ike. To do this, one must open the HUT-CCU and set a dip switch
as follows:
Sony/Hitachi Ikegami
SW1 off on
SW2 off on
SW3 on off
SW4 off off
Either approach to enabling Ikegami CCU operation is valid. The choice is up to you,
although single fiber mode may make some camera system features unavailable.
Note that with some Sony camera systems, the CCU may report an open cable condition.
Despite this, the system will work normally, so you can safely ignore this warning.
3. Specifications
.
SDI Standards Supported, repeater SMPTE 259M/292M/297M/425M, DVB/ASI
SDI Added Jitter, repeater < .03 UI, < 1 MHZ
Laser Safety, repeater Class 1
Optical Connectors, CAM HUT SMPTE 311 Plug + 2 ST/UPC or LC
Optical Connectors, HUT-CCU SMPTE 311 Receptacle + 2 ST/UPC or LC
Optical Wavelengths, nm, repeater 1310. 1550 or CWDM optional
Optical Sensitivity, repeater -18 dBm
Optical Output Power, repeater -2 ~ -8 dBm
Fiber Optic cable length, standard Limited by camera/CCU
Fiber Optic cable length, repeater Up to 20km
Indicators, CAM HUT Unit, standard Cable open/short, HV/status
Indicators, CAM HUT Unit, repeater As above + optical power ok/bad/laserfail
Electrical Output, CAM HUT Unit 230VAC @ up to 250VA, active,
24VAC @ up to25VA, standby
Power Requirement, CAM HUT Unit 115/230VAC, 50/60HZ, 260VA
Power Requirement, HUT CCU Unit Steals power from CCU
Operating Temperature 0 to 70 deg C
Certifications FCC class A and UL/CE
Dimensions, CAM HUT unit 3.5” H x 5.5” W x 10.5” D
Weight, CAM HUT unit 10 pounds
Dimensions, Base unit 2.0” H x 2.5” W x 7.0” D
Weight, Base unit 0.5 pound