MultiDyne SMPTE-HUT - Manual (Page 7)

SMPTE HUT Manual 10/15/2014
Multidyne Electronics Inc.
7
The rear panel is shown in Fig. 3. This drawing shows an optional location of the optical
connectors on the rear. The same considerations concerning the fiber optic connectors
should be observed as on the front panel. Also on the rear is a fused, filtered power entry
module that accepts an IEC cord and a primary power switch. If the optical connectors are
located on the front panel as shown in Fig. 2, then the rear would be completely blank
except for the power entry. If pressing the RESET button after an overcurrent fault has
occurred does not restore power, please check the fuse.
Fig. 3: CAM HUT Rear Panel