Mr. Coffee BVMC-SJX33GT - Manual (Page 7)

b. Water Filtration System (not included with all models)
Using the Mr. Coffee ® carbon-based water filter in the
Mr. Coffee ® coffeemaker during the brewing process helps
remove up to 97% of the chlorine from the water and
improves the taste of your coffee.
First, look for the MR. COFFEE ® Filter Friendly symbol
on the bottom of your filter basket. If you do not see this
symbol, please call 1-800-672-6333.
To use the water filtration system in your MR.COFFEE ®
Coffeemaker, please follow these steps:
1. Align the red indicator on the frame to the letter that
corresponds with the month that you are using the disk for
the first time. This serves to remind you to change the disk
every month (approx. 30 brewing cycles). To change the
disk, slide out the used disk, insert new disk into the frame.
2. Rinse the water filter in fresh water before first use.
3. Follow Adding Water and Coffee instructions.
4. When you are done brewing your coffee, rinse the water
filter with fresh water. Do not put your water filter in the
dishwasher.
NOTE: For optimum results, use the water filtration system
with a permanent filter.
12 13
“brewing Coffee Later” section.
To check the programmed time, push the
SET DELAY button. The display will show
the time you have programmed the coffee
to brew. If you press the SET DELAY button
again or wait a few seconds, the display
will switch back.
PREPARING FOR USE
Selecting and Measuring Ground Coffee
For best results, use a level tablespoon for ground
coffee measurement. Make sure you use medium grind
coffee for a perfect brew.
A. Suggested Coffee Measurement Chart
To brew Ground Coffee
12 Cups 9 tbsp.
10 Cups 7.5 tbsp.
8 Cups 6.5 tbsp.
6 Cups 4.5 tbsp.
4 Cups 3 tbsp.
1 level tablespoon (tbsp) = 5 gr./0.17 oz.
1 cup = 5 fl. oz. of brewed coffee
Use more or less coffee to suit your taste.
Figure 4
Top of filter
Disk & Frame
Red Indicator Permanent
Filter
BVMC-SJXGT_12ESM2.indd 13-14 9/11/12 10:53 AM