Mr. Coffee BVMC-ECX - Manual (Page 6)

SETTING THE CLOCK AND DELAY BREW TIME
To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on the
control panel to indicate that the time has
not been set yet.
2. Press and hold the Hour/Minute Button
until you reach the current time. The AM
or PM indicator will light at the top of the
display ( Figure 1).
The clock is now set!
NOTE: Pressing Select/Off before setting the
clock will cause the clock to start keeping time
from 12:00 a.m. You must set the clock if you
want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply
press the SET DELAY button (Figure 2) and,
while the Amber Delay Brew LED is flashing,
set the brew time by pressing the Hour/Minute
Button. The AM or PM indicator will light at the
top of the clock display. (Figure 3)
Within a few seconds the display will change to
the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see
the “Brewing Coffee Later” section.
To check the programmed time, push the SET DELAY button.
The display will show the time you have programmed the
coffee to brew. If you press the SET DELAY button again or
wait a few seconds, the display will switch back.
PREPARING FOR USE
Selecting and Measuring Ground Coffee
For best results, use a level tablespoon for ground coffee
measurement. Make sure you use medium grind coffee for a
perfect brew.
A. Suggested Coffee Measurement Chart
10 11
To Brew Ground Coffee
12 Cups 9 tbsp.
10 Cups 7.5 tbsp.
8 Cups 6.5 tbsp.
6 Cups 4.5 tbsp.
4 Cups 3 tbsp.
1 level tablespoon (tbsp) = 5 gr./0.17 oz./ 15 ml
1 cup = 5 fl. oz./ 148ml of brewed coffee
Use more or less coffee to suit your taste.
Figure 3
Figure 2
Figure 1
BVMC-ECX41_14ESM1.indd 11-12 10/04/14 2:41 PM