Monster FlatScreen SuperThin Flat Mount - Up to 27” Screens - Manual (Page 7)

8 9
Installing the Wall Mounting Plate
Remove all pieces of the wall mounting system to ensure
you have all necessary parts.
Wood Stud Mounting:
Using an electronic stud sensor, locate a wall stud 1)
at your desired mounting location.
With the help of a friend, position the wall mounting 2)
plate on the wall stud.
,%6%,
#(%#+
3) Suspend a straight edge, such as a ruler,
across the top of the mounting plate. Place the
provided level on the straight edge and confirm that
the wall plate is vertically straight. Hold the plate firmly
in place.
Mark the stud center in the top and bottom mounting 4)
holes with a pencil. With your electrical drill and 3/16"
bit, pre-drill a 3" deep hole at each mark.
Attach the wall plate to the wall using the lag bolts 5)
and round washers as shown to the right. Tighten
each bolt with your electric drill or socket wrench.
Turn clockwise until secure.
DO NOT over tighten bolts. This can damage
the wall plate or the surface of your wall.
DO NOT release the wall plate until you are
absolutely sure it is secured to the wall.
Wood Stud
Lag Bolts and Washers
3/16" Hole
Wood Stud
Flatscreen
Wall Plate
Flatscreen
Wall Plate
LEVEL
CHECK