Monster FlatScreen SuperThin Flat Mount - Up to 46” Screens - Manual (Page 22)

18
ENGLISH
Hanging the TV and Vertical Adjustment
Bars on the Wall Plate
Monster strongly recommends that a minimum
of two people perform the following steps.
DO NOT release the TV until you are certain
it is properly mounted and secured to the
wall plate.
Connect the TV’s power cord and any AV cables to the 1)
TV before hanging it. With the help of a friend, lift the
TV and plug its power cord into a nearby AC outlet.
If routing AV cable in wall, route the cable through
the wall plate’s Pass-Thru slots into the prepared
opening in your wall.
Locate the 2) QuickLift
™
hooks on the back of the Vertical
Adjustment Bars, now attached to your TV.
A cord is attached to the bottom of each vertical 3)
adjustment bar. Pull the cords to open the locking
mechanism, then secure the cord to the notch at the
bottom of the vertical adjustment bar. This will keep
the locking mechanism open while you hang the TV.
Hang the 4) QuickLift
™
hooks on the wall plate’s top
and bottom horizontal channels.
Release the cords from the notch to engage the 5)
locking mechanism on each vertical adjustment bar.