Hook up guide, Connecting to monster greenpower, Outlets – Monster JP 800G User Manual
Page 6
ENGLISH
HOOk UP GUide
Connecting To Monster GreenPower
™
Outlets
Please read these instructions before connecting any equipment to the surge
protector:
ATTENTION:
1. You must connect an electronic device that draws sufficient power in operational
mode to activate GreenPower switched outlets. If you do not, the GreenPower
switched outlets will not deliver power to connected equipment.
2. Some components can take up to 10 minutes to switch to stand-by or sleep
mode. If the Monster GreenPower
™
switched outlets on your surge protector
do not turn off immediately, please wait approximately 10 minutes to allow
the component plugged into GreenPower Control outlet to switch to stand-by
mode. Once this component is in stand-by mode, the GreenPower switched
outlets will turn off, eliminating stand-by energy waste by that component.
WARNING: Important data and settings stored on hard drives (recorded TV shows,
game saves, etc.) may be corrupted or deleted if power is turned off while the hard
drive is being read from or written to.
If you hook up a hard drive-based device such as a TiVo,
®
DVR or video game
console to a “GREENPOWER CONTROLLED” switched outlet, make sure the device
is NOT being read from or written to when you turn off the equipment connected
to the “GREENPOWER CONTROL” outlet.