beautypg.com

Monster AV 775G PowerCenter User Manual

Page 17

background image

ENGLISH

SYMPTOM

POSSiBLE CAuSE

rEMEDY

The PowerCenter

is not

receiving power.

The PowerCenter is not turned On.

Too many devices are connected, causing an overload,
tripping the Circuit Breaker.

• Turn the PowerCenter switch on.

• Make sure the PowerCenter’s AC power plug is plugged into a properly grounded 120 volts (nominal) wall outlet.

• In some households, a wall switch may need to be thrown to make the wall plug active. Try turning on the light switches

located near the wall unit.

• Press the PowerCenter main power switch to “OFF” and then again to “ON” to reset.

Component is not receiving power.

The component is plugged into a GreenPower switched outlet and the
PowerCenter has not been turned On.

The PowerCenter is plugged into a Switched outlet, but power on the
component is not On. In some instances, a component plugged into a
switched outlet won’t receive power when the PowerCenter is turned
On unless the component power is also switched On.

The component is plugged into a GreenPower switched outlet
and the component connected to the GreenPower Control Outlet
has not been turned On.

• Turn the PowerCenter On.

• Turn On the component plugged into the Switched outlet.

• Turn On the component plugged into the GreenPower Control outlet.

Speakers emit a humming
or buzzing noise.

The PowerCenter is sharing AC power with equipment
that is not properly grounded.

• Connect your PowerCenter to a dedicated outlet.

• Try unplugging different components from the PowerCenter one at a time to see if the noise stops.

• Make sure all components are plugged into PowerCenter.

“Ground OK” Diagnostic Indicator Light
does not come on.

Make sure PowerCenter is plugged into grounded outlet.

Contact a qualified electrician to check outlet(s) for proper grounding.

Alarm beeps continuously.

The PowerCenter protection circuitry has sacrificed itself to protect
connected equipment from a catastrophic surge.

The PowerCenter must be replaced. See the Warranty Information section for important details.