Troubleshooting, Specifications – MMD Equipment IGR3000 User Manual
Page 19

MMD PowerPro Inverter Generators • IGR3000 (041715)
MMD PowerPro Inverter Generators • IGR3000 (041715)
Page 36
Page 37
Engine will not start
Problem/Possible cause
Corrective action
No fuel in tank
Refuel with gasoline
Fuel switch not on
Turn fuel switch to ON position
Not enough oil in engine
Refill with recommended oil
Fuel not reaching carburetor
How to check:
1. Turn off fuel valve and loosen drain screw
2. See if fuel is flowing from drain when fuel valve is turned
on.
If the engine still does not start, please take the generator
to an authorized dealer.
No spark from spark plug
Check spark plug or replace spark plug
How to check spark plug:
1. Remove spark plug cap and clean any debris off sparkplug.
2. Remove spark plug and install spark plug in the plug cap.
3. Set the plug-side electrode on the cylinder head to the ground.
4. Pull the recoil starter. Sparks should jump across plug gap.
If the engine still does not start, please take the generator to an authorized dealer.
Appliance does not operate
Problem
Corrective action
Output indicator not on
Check appliance/equipment for defects
Overload indicator on
1. Replace appliance/equipment, or have repaired.
2. Stop and restart engine and try again.
If still not operational, please take the generator to an authorized dealer.
No power to the DC receptacle
Problem
Corrective action
DC circuit fuse blown
Replace fuse
If still not operational, please take the generator to an authorized dealer.
10. Troubleshooting
Make sure there is no spilled gasoline around spark plug. Spilled fuel may ignite.
11. Specifications
Model
IGR3000
Rated Output, watts
2800
Rated Current, amp
23.3
Maximum Output, watts
3000
Phase
Single
Parallel operation allowed
No
Maximum Current, amp
25.0
AC Voltage
120
Frequency, Hz
60
DC Output
12V @ 5A
HP @ rated RPM
5.36 @ 3600
Starting System
Recoil/Electric
Engine Type
Air cooled, single cylinder, 4-stroke, OHV with
electronic ignition
Displacement, cc
196
Compression Ratio
8.5:1
Ignition System
Transitionized
Spark Plug
WR7DC
Fuel
Regular unblended automotive gasoline
(87-octane)
Lube Oil
SAE 10W30 (see viscosity chart)
Oil Capacity - qt. (L)
0.63 qt. (0.6L)
Noise Level, no load-full load, dB @ 23
ft.
63-73
Rated load continuous run time, hrs.
8
Fuel tank capacity, gal.
3.4
Dimensions, LxWxH, in.
27.5 x 17 x 19.9
Dry Weight, lb.
132.3
Receptacles
125V GFCI 20A; L5-30R 125V T-Lock 30A
Tune Up Specifications
Spark Plug Gap
0.028 – 0.031 in. (0.7-0.8 mm)
Valve Clearance (Intake)
0.0039 ± 0.0008 in. (0.10 ± 0.02 mm)
Valve Clearance (Exhaust)
0.0059 ± 0.0008 in. (0.15 ± 0.02 mm)