MK Products Positioner #2 - Manual (Page 8)

#2 Positioner - Owner's Manual Page 1
FEATURES
OPERATING
PROCEDURE
1. Connect positioner to 115 VAC power source.
2. Connect welding ground cable to grounding lug assembly on positioner.
3. Set high/low range switch to proper position.
4. Set forward/reverse switch to proper position.
5. Establish desired speed setting using the rheostat on the positioner.
6. Depress foot control to activate positioner.
NOTE: Failure to attach the welding ground cable to the grounding lug assembly
will result in damage to the positioner electrical circuit.
Tilt Release/
Locking Knob
Foot Control
Rheostat
Stepless
Speed
Control
Fuse
Forward/
Reverse
Switch
High/
Low
Range
Switch