MK Products Positioner #3 - Manual (Page 6)

#3 Positioner - Owner's Manual Page 1
FEATURES
OPERATING
PROCEDURE
1. Connect positioner to 115 VAC power source.
2. Connect welding ground cable to grounding lug assembly on positioner.
3. Set high/low range switch to proper position.
4. Set forward/reverse switch to proper position.
5. Establish desired speed setting using the rheostat on the positioner.
6. Depress foot control to activate positioner.
NOTE: Failure to attach the welding ground cable to the grounding lug assembly
will result in damage to the positioner electrical circuit.
Forward/
Reverse
Switch
High/Low
Ran Switch
Foot
Control
Rheostat
Tilt
Release/
Locking
Lever
Tilt
Degree
Indicator
Fuse
Declutching
lever
Stepless Speed
Control
Hollow Gas
Purging Shaft
(Gas connection
not shown)