beautypg.com

Sp-1 connection configuration con’t – MK Products Sidewinder User Manual

Page 22

background image

Sidewinder

®

MiniSpool™ Gun Owner's Manual - Page 14

For many Miller (Fig. 3) and Lincoln (Fig. 4) welding power supplies, a 14-pin
connector offers power to the SP-1 module and the trigger signal for contact
closure.

Figure 3

In addition to Miller and Lincoln units, many other manufacturers also utilize

the same type of 14-pin connector, with the same pinouts and clocking.
Consult the power supply owner’s manual and or manufacturer for pin
location and labels.

Figure 4

Once the power is connected and turned on, the gun motor is live. Pull the gun
trigger to engage the motor and use the knob on the SP-1 to adjust the wire
speed.

To measure wire speed, pull trigger for 6 seconds and measure wire length.
Multiply measured length of wire by 10 for true IPM (inches per minute).

Approximate wire speeds, by diameter, to achieve 80-100A @ 18-20VDC,
depending on aluminum wire alloy and power supply output:

.023 wire: 525ipm

.030 wire: 425ipm

.035 wire: 350ipm

SP-1 Connection Configuration Con’t.