MK Products Prince XL - Manual (Page 17)

Prince ® XL/Spool Gun Owner's Manual - Page 10
ESAB (L-TEC) / MigMaster 250
P/N 005-0206
An amphenol adaptor cable and gas/power lug
are all that is needed to connect to the Migmaster.
Adaptor kit includes everything needed.
MillerMatic 250 & Vintage / Hobarts BetaMig 2510
P/N 005-0205
This easy to install, plug in module fits the Millermatic 250, Miller
Vintage machine, or Hobart Betamig 2510. It and a Prince Spool
Gun are all that is needed to get your customer up and running.
Panasonic Gunslinger 260
P/N 005-0617
Easy to install adapter cable using Gunslinger speed
control.
ESAB MigMaster 251
P/N 005-0624
A panel kit plugs directly into the front of the MigMaster
251 and includes everything that is needed to interface the
spool gun.
MillerMatic 250X/251
P/N 005-0629
Easy to install adapter cable using MillerMatic 250X
speed control. Reference Tech Bulletin TB 2112
found at mkproducts.com for Millermatic/Prince XL
spool gun compatibility.
Fabricator 250
P/N 005-0689
Easy to install adapter cable using Thermal Arc
Fabricator 250.
NOTE: For further information on spool gun adaptability contact
MK Products.
Section D Maintenance
Maintenance of the gun will normally consist of a general cleaning of the wire
guide system, including tubes, drive rolls, and conduit at regular intervals.
Remove spatter build-up from inside of nozzles with a hardwood stick.
The only parts on the gun that are subject to normal wear are the conduit,
contact tips, gas cups, drive and idler rolls and barrel liners. A supply of
those parts should be maintained on hand.
If repairs do become necessary, qualified shop maintenance personnel can
easily replace any parts.
Your Cobramatic
® System is designed to provide years of reliable service.
Normal wear and component failure may require occasional service.
The number of units in operation and the importance of minimal “down time”
will determine to what extent spare parts should be stocked on hand. See
the “Recommended Spart Parts List” for the most commonly replaced parts.
Panasonic Gunslinger 260
ESAB MigMaster 251
MillerMatic 250X &
Fabricator 250
Thermal Arc Fabricator 250
ESAB (L-Tec-Linde) MigMaster 250
MillerMatic 250, Vintage
and BetaMig 2510