MK Products CobraMAX - Manual (Page 14)

CobraMAX™ Owner's Manual - Page 6
Section D Maintenance
Periodic Maintenance
Your Cobramatic system is designed to provide years of reliable service.
Maintenance of the gun will normally consist of a general cleaning of the wire
guide system, including barrel, drive rolls, and conduit at regular intervals.
Remove spatter build-up from inside of nozzles with a hardwood stick.
The only parts on the Cobramatic system that are subject to normal wear are
the conduit, contact tips, gas cups, front body liners, wire guides, drive and
idler rolls. A supply of these parts should be maintained on hand.
The number of units in operation and the importance of minimal downtime
will determine to what extent spare parts should be stocked on hand. See
the recommended spare parts list for the most commonly replaced parts.
If repairs do become necessary, qualified shop maintenance personnel can
easily replace any part.
Maintenance Tools
Tool Part Number
Contact tip removal tool 931-0002
Drive roll removal tool 931-0100
Gas valve removal tool 931-0584
Recommended Spare Parts List
Qty. Part no.
Description
1 615-0601-35 Conduit - 15 ft
1 615-0601-35 Conduit - 25 ft
1 615-0601-35 Conduit - 35 ft
1 615-0601-35 Conduit - 50 ft
1 437-0253 Drive roll door
2 005-0694 Trigger assy kit
2 005-0695 Potentiometer assy kit
1 005-0700 Handle kit
2 005-0701 Micro switch assy kit
10 511-0101 Drive roll
5 005-0686 Idler roll kit
KNURLED DRIVE ROLL
511-0101
DRIVE ROLL
REMOVAL TOOL
931-0100
MICRO SWITCH ASSY
005-0701
IDLER ROLL KIT
005-0686