MK Products CobraCooler - Manual (Page 10)

CobraCooler ® Owner’s Manual - Page 2
Section 5 Operation
5.1 Coolant
CAUTION
COOLANT MUST BE ADDED PRIOR TO OPERATING.
From the top of the CobraCooler ®
, open the access panel, unscrew the fill
plug and pour in the coolant.
DO NOT SPILL COOLANT INTO THE UNIT.
An electrical short may occur if coolant is spilled into the unit
It is recommended that all coolant be removed from the CobraCooler ® prior to
shipping. After draining, some coolant may still remain in the internal pump,
radiator, filter, and circulatory tubing.
Section 6 Accessories
Weldhead Extension Cable
Weldhead extension cable, P/N 005-0635. It comes complete with all the
necessary cabling to adapt the MK orbital weldheads: control cable with 24
pin connector, electrode and ground cables, inert gas hose and water hose
assembly with quick-disconnect connectors. This 25 ft. extension cable is to
mate any of the MK CopperHead
® series weldheads to the CobraCooler ® . A
50 ft is also available under P/N 005-0635-50.
Section 7 Spare Parts
7.1 Fuse
WARNING
DISCONNECT UNIT FROM ALL POWER SOURCES PRIOR TO
CHANGING FUSE.
ELECTRIC SHOCK CAN KILL
Located on the rear panel of the CobraCooler ® is a 0.50 amp BUSS fuse.
If the unit does not turn on with the power switch, check the integrity of the
fuse.
Turn the fuse cap on the front panel and remove fuse. Check fuse using
continuity meter. Replace if necessary.
7.2 Coolant Flow Filter
WARNING
DISCONNECT UNIT FROM ALL POWER SOURCES PRIOR TO
CHANGING MESH FILTER.
ELECTRIC SHOCK CAN KILL
Periodically, the mesh-screen filter may require cleaning and/or replacement.
Replaceable Parts List
Description Part Number
Fuse 151-0043
Mesh Filter 567-0012